Welch Allyn SCANTEAM 3470 CCD Specifications Page 7

  • Download
  • Add to my manuals
  • Print
  • Page
    / 11
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 6
3
Cordless Quick Start Guide
Note: It is important that you charge a NiCad battery
for 48 hours prior to first use. No damage
occurs if this is not done, but the battery
capacity will not be at 100%. A NiMH battery
requires charging for only 24.5 hours.
Recharge Time (NiCad or NiMH):
8 hours at 120 VAC, 50/60 hz
Cordless
Scanner
Charge the Battery Pack by following the steps shown below:
Rechargeable
Battery Pack
The LED on the bottom of the battery pack will
light red when the unit is charging; it shows
green when it is fully charged and ready to use.
After battery pack is fully charged, attach to the
Cordless Scanner by pressing the pack firmly (align
the prongs on the pack with the mating receptacles)
in the base of the scanner until the release buttons
click, holding the pack firmly in place.
(When you
attach a charged battery pack to the Cordless
Scanner, you will hear a single beep.)
If you haven’t set up your Cordless System, refer to the “Setting Up and
Connecting the Cordless System” section in the System Manual for
instructions.
Charging Your Battery Pack
Plug the battery pack into a wall socket in North America
only
. Failure to
comply could result in equipment failure.
When the battery pack needs recharging, the yellow LED on top of the scanner
pulses in short, continuous blinks and the scanner won’t beep when you pull the
trigger. If the LED stops flashing when the temperature lowers or you do not use
the battery pack for some time, you still need to charge the battery pack to avoid
damaging the battery pack or causing scanner memory loss.
Battery
Pack Clip
(2 Places)
Fully charge the battery (see page
2). Plug the battery pack directly
into any common 120 Volt AC outlet
in North America. If outside North
America, use the step down
transformer provided with the
scanner.
Page view 6
1 2 3 4 5 6 7 8 9 10 11

Comments to this Manuals

No comments