Welch Allyn SCANTEAM 3470 CCD Specifications download pdf (Page 21)

2–1

Cordless Systems Manual

Introduction

Use this section to program the Cordless System to work with your terminal or

computer (host system).

This programming section contains the following menu selections:

• Keyboard

• Wand Emulation

Section 2 Quick Start & Interface Menu

• Terminal Interface

• Country Code

• Laser, Reset Factory Settings, and Status

• Output Delays

All operating parameters are stored in non-volatile memory resident in the

Cordless System, where they are permanently retained in the event of a power

interruption. When you receive your Cordless System, certain operating

parameters have already been set. These are the factory defaults, indicated by

the symbol “✱” on the programming pages (beneath the default programming bar

code). Default Charts that list all the factory settings may be found near the end

of this Systems Manual.

A Programming Chart (found on the inside back cover of this manual) contains

alphanumeric bar codes for setting additional programming options, such as the

digits representing Symbology Message Length. The chart explains how and

when to use the alphanumeric bar codes.

A Sample Bar Codes page (located on the back cover of this manual) provides

bar code symbols you may scan to verify that your Cordless System has been

programmed correctly and is communicating with your host system.

• Plug and Play

Note: After scanning the following menu selections, there will be a pause (up

to 20 seconds) while the Base unit processes and uploads the new menuing

information to its parameter tables:

Plug and Play Selections (on the next two pages)

Factory Default Settings: ALL Application Groups (last page, Section 2)

Application Work Group Selections (Section 4)

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 107 108

No comments

Welch Allyn SCANTEAM 3470 CCD Specifications Page 21