Welch Allyn SCANTEAM 5770 LASER Specifications download pdf (Page 6)

Associating the Cordless Scanner to a Base

Important:Make sure the cordless scanner’s battery pack has been fully

charged. See page 2 for charging instructions.

Using the cordless scanner, scan the Association Bar Code (the bar code label

on the top of the base) to link that scanner to the base.

Two quick beeps followed by clicking, then a single beep indicates a “good”

association. The scanner is in communication with the base.

If the battery pack is removed from the scanner and replaced after association,

the scanner automatically reassociates to the base if the base has power. In this

case, the scanner beeps when a charged battery pack is installed, then beeps a

second time after full association, usually five to ten seconds later.

Note: To set up and connect the cordless system to the host system, refer to the

Cordless System Manual. The System Manual includes all programming

selections, more detailed explanations of the cordless system, product

specifications, scan maps, connector illustrations and pinouts,

maintenance, and troubleshooting information.

Obtaining Factory Service

Hand Held Products provides service for all its products through a service center

located at its manufacturing facilities in Skaneateles, New York. To obtain warranty

or non-warranty service, return the unit to Hand Held Products (postage paid) with a

copy of the dated purchase record attached.

In the United States, please contact the Hand Held Products’ Product Service

Department at the address/telephone number that follow to obtain a Return Material

Authorization number (RMA #).

1 2 3 4 5 6 7 8 9 10 11 12

No comments

Welch Allyn SCANTEAM 5770 LASER Specifications Page 6