Pocket Guide
Verify that the sensor is placed below the mattress, under the
chest area, or that the chair sensor cushion is secured
correctly to the back of the seat.
Admit the patient: Enter ID, Room and Bed no. Assign the
patient by choosing your color.
Assess the patient and adjust the parameters on EarlySense
Bed-Side as relevant :
Patient in risk of fall / wandering Enable Bed Exit Alert.
Set the alert sensitivity.
Patient under Turn Protocol Enable Patient Turn
Counter
Change in HR high / Low threshold required? Consult
supervisor
Change in RR high / low thresholds required? Consult
supervisor
Choose the correct mode according
to the patient’s location.
During hospitalization - adjust the parameters to the patient’s
condition if needed.
Is the patient leaving? Discharge the patient.
Comments to this Manuals