Welch-allyn Propaq LT v1.60.07 Update Application - Installati User Manual download pdf

80019284 B 1

Propaq LT v1.60.07 Update Application – User Instructions

1. Required Equipment

 Propaq LT v1.60.07 Update Application CD (410440)

 Propaq LT Power Adapter (503-0142-01)

 USB/Comm Charging Cradle (008-0873-00/007-0164-00)

 USB cable, type A-B (008-0882-00 or equivalent)

 PC with one of the following operating systems: XP Service Pack 3, Windows 7 (32/64 bit)

PC admin rights are required to install the Update Application to a PC.

To avoid possible driver conflicts, uninstall any other Welch Allyn utilities or install the Update

Application on a PC that has no other Welch Allyn utilities installed.

Important: If you have a model 802LTAN and have temporarily disabled your wireless (radio)

communications and intend to re-enable the radio at some point, please see Section 4.

Note: After the software update, the Propaq LT configuration settings will be reset to factory defaults.

2. Installation

1. Insert the Propaq LT v1.60.07 Update Application CD into the CD/DVD drive of the installation PC.

Depending on your PC settings, Windows AutoPlay may start the installation or provide the option to

run setup.exe. If AutoPlay doesn’t start, browse the CD and run setup.exe.

1 2 3 4 5 6 7 8 9 10

80019284 B 1 Propaq LT v1.60.07 Update Application – User Instructions 1. Required Equipment  Propaq LT v1.60.07 Update Application CD (410

80019284 B 10 4. If You Have Disabled Your Propaq LT Wireless (Radio) Communications 1. If you have a model 802LTAN and have temporarily disa

Page 3

80019284 B 2 2. During installation, Windows may indicate the installation is from an unknown publisher. Click Run to install anyway. 3.

80019284 B 3

Page 5

80019284 B 4

80019284 B 5 Note: Perform step 4 after installation of the update application and before initial use. This allows the USB drivers to be instal

Page 7

80019284 B 6 The following warning appears. Click Continue Anyway. 5. Click Finish.

80019284 B 7 3. Update a Propaq LT 1. Disconnect all patient cables from the Propaq LT, and make sure that the NIBP mode is set to Manual. 2.

Page 9

80019284 B 8 7. Wait for the Propaq LT serial number to appear. 8. The Update Application will determine the status of the connected Propaq

80019284 B 9 Propaq LT in Update (Bootcore) Mode with Front LEDs Flashing Update Application: Bootcore/Main Updates, Update Completed 12.

No comments

Welch-allyn Propaq LT v1.60.07 Update Application - Installati User Manual