Welch-allyn 40 inch Integrated Diagnostic System Wall Panel (7 User Manual download pdf

4341 State Street Road

Skaneateles Falls, NY 13153 USA

Phone: (800) 535-6663 (US Only) or (315) 685-4560 • Fax: (315) 685-3361

www.welchallyn.com

40” Integrated Wall Panel (order #76790-6)

Unpacking

• Concealed damage: if you notice any damage after unpacking, notify the

transportation company at once to inspect the damage. Require them to give

you a “concealed” bad order report stating the condition of the goods when

examined. If necessary, insist it is their duty to perform this action.

If you comply with the above instructions, we will provide assistance in

establishing claims against the transportation company for loss and damage

in transit.

• We do not accept goods returned for credit, exchange, or repairs, or for any

other reason, unless you have first contacted Welch Allyn and have our

written permission.

Installation

The Integrated Panel is mounted to the wall using a steel mounting bracket and

hardware (provided).

1. Choose a location for the Integrated Panel near the examination table and an

electrical outlet. See Figure 1.

2. Mark the location using the measurements shown in Figure 2.

3. Locate and mark the studs in reference to the measurements in step 2.

For steps 4 through 6: when securing the mounting bracket to a wall with

metal studs, replace the drywall screws with sheet metal screws. When

securing the mounting bracket to a masonry/concrete block wall, replace the

drywall screws and wall anchors with masonry screws.

4. Place the mounting bracket in the marked wall location and mark the

locations of all fasteners. Remove the mounting bracket and drill a 3/8” hole

for each wall anchor. Drill three holes if a wall stud is located or four holes if a

wall stud is not located.

5. Install a wall anchor in each hole, if necessary. Install a screw in each wall

anchor and tighten enough to secure the wall anchor in place. Remove the

screws.

6. Attach the mounting brackets to the wall with the screws. Level the mounting

bracket before securing it to the wall.

7. Test the mounting bracket for strength.

8. Mount the Welch Allyn products to the Integrated Panel using Figure 3, 4, or

5 to properly position the instruments.

Aneroid Blood Pressure Gauge: position the gauge bottom on the single pre-

installed screw and then secure the top of the gauge in place using the two

additional screws provided.

Hanging basket: position the thermometer on the two pre-installed screws,

and then secure in place using the two additional screws provided.

Install the remaining instrument assemblies on the pre-installed mounting

screws.

For Diagnostic Systems without SureTemp

thermometry, use the two

color-coated FastCaps. Remove the backing from the FastCap and adhere it

over the unused screw hole.

Figure 1. Suggested Room Layout

Manufactured for Welch Allyn by Heartwood. P/N: HRT 1037 Material No. 707809 Ver. C

Caution Welch Allyn is NOT responsible for the integrity of any wall

mounting interface. Welch Allyn recommends that the customer contact

their Biomedical Engineering Department or maintenance service to

ensure professional installation, safety, and reliability of any mounting

accessory.

CASEWORK

INTEGRATED

PANEL

STOOL

EXAM

TABLE

DRESSING NOOK

SIDE

CHAIR

10’-0”

8’-0”

1 2

Summary of Contents

Page 1 - Installation

4341 State Street RoadSkaneateles Falls, NY 13153 USAPhone: (800) 535-6663 (US Only) or (315) 685-4560 • Fax: (315) 685-3361www.welchallyn.com40” Inte

Page 2 - INTEGRATED

FLOORINTEGRATEDPANEL2 3/4”12”67 7/8”40”Figure 2. MOUNTING BRACKET WALL POSITIONINGFigure 3. INSTRUMENT LOCATION - WITHOUT THERMOMETERAneroid Blood Pre

Comments to this Manuals

No comments

Welch-allyn 40 inch Integrated Diagnostic System Wall Panel (7 User Manual

Browse online or download User Manual for Equipment Welch-allyn 40 inch Integrated Diagnostic System Wall Panel (7. Welch Allyn 40 inch Integrated Diagnostic System Wall Panel (76790-6) - Installation Guide User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Equipment Welch-allyn 40 inch Integrated Diagnostic System Wall Panel (7