Welch-allyn Spot Vital Signs - User Manual User Manual download pdf (Page 30)

22 Welch Allyn Spot Vital Signs

Quick Reference/Error Code Card

The Quick Reference/Error Code Card should be attached either to the Spot Vital Signs

handle, the Mobile Stand, or the Wall Mount.

AC Power Connection

Use the Spot Vital Signs with AC or battery power (after charging the battery).

1. Insert the round transformer connector into the AC power connection port on the left

of the Spot Vital Signs (see page 18).

2. Insert the line cord into the line connector on the transformer then plug the power

cord on the transformer into the AC main power source to charge the battery.

Charging the Battery

CHARGE THE BATTERY FOR SIXTEEN (16) HOURS PRIOR TO INITIAL USE.

Attach the AC power transformer to the Spot Vital Signs then plug the transformer into

the AC main power source.

While charging, the charger icon remains on and the battery icon segments continuously

sequence. When the battery is fully charged, all battery icon segments display.

As the battery voltage level drops the segments turn off from left to right. If the Spot Vital

Signs is not plugged in to charge when the second last segment is turned off the Spot

Vital Signs issues a warning beep. As the voltage level drops to compromise

measurements an error beep is heard and all other display fields turn off. Spot Vital Signs

beeps at increasingly frequent intervals until it finally powers itself off.

If not used for extended periods of time then recharge the battery.

Standby Mode

When the device is powered up, but has not been used for 2 minutes, it goes into

Standby Mode. “Z Z Z” appears across the top of the display with no backlight. Standby

Mode conserves battery power.

To bring the Spot Vital Signs out of Standby Mode, press the Mode or Pressure Preset

button or begin a patient measurement.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 73 74

No comments

Welch-allyn Spot Vital Signs - User Manual User Manual Page 30