Welch-allyn Spot Vital Signs - User Manual User Manual download pdf (Page 61)

Maintenance

Welch Allyn will make available,upon request, circuit diagrams and other information

which will assist appropriately qualified technical personnel in repair of this device. Please

reference “4200-89E” on page 61.

Cleaning

Spot Vital Signs

Occasionally wipe the Spot Vital Signs, as necessary, with a cloth slightly dampened with

appropriately diluted, non-staining disinfectant solution. Use either 70% isopropyl alcohol,

10% chlorine bleach solution, or mild detergent in warm water. Never immerse the Spot

Vital Signs in any type of fluid.

Blood Pressure Cuff

Clean the blood pressure cuff with a damp cloth, or wash in water with soap or detergent.

Before washing the blood pressure cuff, remove the tube fitting(s), close off tubes with

plugs (available as accessory 5082-163) and place the hook and loop fasteners in the

closed position. After washing, allow the blood pressure cuff to air dry. Re-assemble the

tube fitting(s).

Disinfection: You may use glutaraldehyde-type liquid disinfectants on the durable blood

pressure cuff. Prolonged use of these disinfectants at full strength may cause

discoloration of the white blood pressure cuff markings.

Sterilization: Do not use steam or heat to sterilize the blood pressure cuff or pressure

hose. If necessary, use gas sterilization.

Caution Do not use ethyl alcohol to clean the Spot Vital Signs device.

Caution Do not sterilize or autoclave the Spot Vital Signs.

Note

Prevent water or other fluids from entering any connectors. Should this occur, dry

the connectors with warm air. Check all measurement functions for proper

operation.

Caution Do not press with a hot iron.

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 73 74

No comments

Welch-allyn Spot Vital Signs - User Manual User Manual Page 61