Welch Allyn IMAGETEAM 3800 User's Guide download pdf (Page 90)

7-22

Telepen, continued

Message Length

The message length selection is used to set the valid reading length of the bar

code. If the data length of the scanned bar code doesn’t match the valid reading

length, the scanner will issue an error beep. You may wish to set the same value

for minimum and maximum length to force the scanner to read fixed length bar

code data. This helps reduce the chances of a misread.

EXAMPLE: Decode only those bar codes with a count of 9-20 characters.

Min. length = 09 Max. length = 20

EXAMPLE: Decode only those bar codes with a count of 15 characters.

Min. length = 15 Max. length = 15

For a value other than the minimum and maximum message length defaults,

scan the bar codes below, then scan the 2-digit value and Save bar codes on the

Programming Chart inside the back cover. Minimum and Maximum

lengths = 1-60.

Note: Ifyoumakeanerror while scanning thedigits (before scanning Save),

scan Discard on the back cover,scan the Minimum or Maximum bar

code,scan the correct digits, and Save again.

Minimum (Default =1)

Maximum (Default =60)

1 2 ... 85 86 87 88 89 90 91 92 93 94 95 ... 173 174

No comments

Welch Allyn IMAGETEAM 3800 User's Guide Page 90