Welch Allyn SCANTEAM 5770 LASER Specifications download pdf (Page 39)

2 - 1

Quick Start & Interface Menu

Introduction

Use this section to program the cordless system to work with your terminal or

computer (host system).

This programming section contains the following menu selections:

• Plug and Play

• Terminal Interface

• Country Code

• Keyboard

• Output Delays

• Wand Emulation

• Power Settings

• Reset Factory Settings and Status Check

All operating parameters are stored in nonvolatile memory resident in the

cordless system, where they are permanently retained in the event of a power

interruption. When you receive your cordless system, certain operating

parameters have already been set. These are the factory defaults, indicated by

an asterisk (*) on the programming pages (beneath the default programming bar

code). Default Charts that list all the factory settings may be found near the end

of this System Manual.

A Programming Chart (found on the inside back cover of this manual) contains

alphanumeric bar codes for setting additional programming options, such as the

digits representing Symbology Message Length. The chart explains how and

when to use the alphanumeric bar codes.

A Sample Bar Codes pages (located near the back of this manual) provides bar

code symbols you may scan to verify that your cordless system has been

programmed correctly and is communicating with your host system.

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 199 200

No comments

Welch Allyn SCANTEAM 5770 LASER Specifications Page 39