Welch Allyn SCANTEAM 2380 WAND Specifications download pdf (Page 22)

3–2

Set–Up and Installation

The proper “Y” Interface Cable connections are illustrated in Figure 3.1.

Converter Cable

configurations

Mini–DIN

DIN

Mini–DIN

DIN

Configuration 2Configuration 1

Figure 3.1 “Y” Interface Cable Connections

a) If you are connecting to an AT/XT terminal, plug the mini–DIN

end of the converter cable into the mini–DIN end of the “Y” interface

cable (configuration 1). If you are connecting to a PS/2 terminal, plug

the DIN end of the converter cable into the DIN end of the “Y” interface

cable (configuration 2).

b) Disconnect the keyboard plug from the host device and insert it

into the mating connector on the short leg of the “Y” interface cable.

c) Complete the cable installation by inserting the converter cable

into the keyboard connector port on the host device.

2) When the SCANTEAM 2380 is fully connected, restore power to the

host unit by turning the power switch ON.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 67 68

No comments

Welch Allyn SCANTEAM 2380 WAND Specifications Page 22