Welch Allyn SCANTEAM 2380 WAND Specifications download pdf (Page 35)

4–11

Programming the Scanner

SHIFT LOCK

When you are operating in SHIFT LOCK mode, the 2380 should also be

programmed for SHIFT LOCK mode (i.e., SHIFT LOCK enabled).

Intercharacter Delay

Intercharacter Delay is the time delay between data characters output by

the 2380. The delay is in (X5) milliseconds and can be set to any value

between 00 and 99 (X5ms).

Interfunction Delay

Interfunction delay is the time delay between “function key” characters

output by the 2380. The delay is in (X5) milliseconds, and any value

between 00 and 99 (X5ms) may be selected.

Intermessage Delay

Intermessage delay is the time delay between messages output by the 2380.

The delay is in (X5) milliseconds and can be set to any value between 00

and 99 (X5ms).

Beeper

This programming selection permits control of the beeper located in the

scanner as a means of indicating scanning activity to the operator. The

BEEPER option described below is listed on the Programming Menu.

Beep (On Reset)

When “Beep” (On Reset) is enabled (YES), the beeper in the scanner will

“beep once” to indicate that the wand is operational. This single “beep” can

be interpreted as a SCANNER READY message from the wand.

Beep (On Good Read)§

When “Beep” (On Good Read) is enabled (YES), the beeper in the scanner

will “beep once” following a scan only if the bar code data has been

accepted by the host. If the beeper does not sound, the scan should be

repeated.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 67 68

No comments

Welch Allyn SCANTEAM 2380 WAND Specifications Page 35