Welch Allyn SCANTEAM 2380 WAND Specifications download pdf (Page 38)

4–14

Programming the Scanner

RX Interrupt§

Occasionally, keyboard activity will cause the wand to beep intermittently

or turn off. This menu selection will prevent this from happening.

4.8 SYMBOLOGY SELECTION (CODES) Menu Page

This Menu Page is used to program decoding selections. The 2380 can be

configured to recognize and decode up to nine (9) popular bar code

symbologies by scanning the proper code enabling (Selection) symbols on

this Programming Menu page. After a particular code has been enabled,

scanning the associated (Variable) code(s) will further program that

symbology’s decoding parameters.

Keep in mind that at power–up (or upon reset), the wand will automatically

configure operating parameters to the last programmed values. Code

options which are enabled (YES) will become the active operating

parameters unless they are changed by the proper configuration command.

Code options with an asterisk (*) next to the (NO) will automatically be

disabled unless they are changed by the proper configuration command.

Note: To obtain maximum security when scanning bar codes, it is

recommended that only those symbologies actually being used be

enabled. Symbologies not being used should be disabled. Additional

data security can be achieved by programming the maximum and

minimum character counts when they are known.

Minimum Length

A two (2) number code which describes the minimum number of characters

that will permitted in the bar code message. The code length must always

be represented by two digits. For lengths less than 10 characters, a zero (0)

should be used as a filler, for example, (05).

Maximum Length

A two (2) number code which describes the maximum number of

characters that will be permitted in the bar code message.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 67 68

No comments

Welch Allyn SCANTEAM 2380 WAND Specifications Page 38