Welch Allyn SCANTEAM 2380 WAND Specifications download pdf (Page 31)

4–7

Programming the Scanner

Preamble characters may include Code ID and the ASCII characters

(00–7F). These characters will be transmitted in the order in which the

selections are programmed.

Both preamble and postamble menuing must always start with a clean

slate. Therefore, to clear all preambles, it is necessary only to complete the

programming sequence SCAN ENTER, SCAN I, SCAN EXIT.

If the Code ID is selected as a preamble, the wand will transmit a single

lower case ASCII character to identify which symbology was decoded.

For example, Code 3 of 9 is identified by a lower case “b,” while Code 128

is identified by a lower case “j.”

The code identifier for each bar code symbology is listed below and

appears immediately following the symbology name on the Symbology

Selection Menu Page.

SYMBOLOGY CODE ID

CODABAR a

Code 3 of 9 b

UPC c

EAN d

Interleaved 2 of 5 e

Code 2 of 5 f

MSI g

Code 11§ h

Code 93 i

Code 128 j

Postamble

Postamble(s) are programmable data identifiers which follow the bar code

messages. Up to five (5) postambles which include the ASCII characters

(00–7F) can be programmed. Postamble characters will be transmitted in

the order in which they are selected. Since postamble selections also begin

with a clean slate, the programming sequence SCAN ENTER, SCAN II,

SCAN EXIT will remove existing postambles from the decoder

configuration.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 67 68

No comments

Welch Allyn SCANTEAM 2380 WAND Specifications Page 31