Welch Allyn SCANTEAM 2380 WAND Specifications download pdf (Page 23)

3–3

Set–Up and Installation

3.4 Scanner Checks

1) Confirm Scanner Operation

If you are using a wand which has visible red illumination, the tip of the

scanner should glow red indicating that the wand is operational. In

addition, at power–up, the beeper in the scanner should issue one (1)

“beep” (if the 2380 has been programmed to “beep” on reset).

2) Check Bar Code Labels

Before using any bar code scanner, make sure the label is of good quality

and that the window area of your scanner is clean. This is very important

because any dirt or specks in the bar code symbol or on the scanner optics

may prevent it from reading accurately. Even a label that is smudged

during printing or gets wrinkled when it is applied to an item can cause a

reading problem.

This completes installation of the wand to the host system. The wand

decoder must now be configured to the particular decoding application.

Instructions for programming the SCANTEAM 2380 decoded output

scanner keyboard wedge using the bar code menu are contained in

Chapter 4.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 67 68

No comments

Welch Allyn SCANTEAM 2380 WAND Specifications Page 23