Welch Allyn SCANTEAM 2380 WAND Specifications download pdf (Page 25)

4–1

Programming the Scanner

PROGRAMMING THE SCANNER

4.1 Introduction

Before the SCANTEAM 2380 can be placed in operation, it must be

configured to the particular application by scanning bar code symbols from

the Programming Menu.

As program sequences are decoded by the 2380, both the desired operating

parameters and data format instructions are stored in nonvolatile memory

on the decoder pc board. A beeper is used to indicate scanning activity.

The following relationships apply:

1) The internal beeper will emit two (2) beeps when entering or exiting

the programming mode (i.e., immediately following a scan of the

ENTER and EXIT labels, respectively).

2) When operating in the programming mode, each successful

programming entry (decoder selection) will be acknowledged by a

single “good read” beep.

4.2 The Programming Menu

The complete SCANTEAM 2380 Programming Menu consists of six (6)

pages: five Menu Pages and the Bar Code Chart. The five menu pages are

labeled: TERMINAL SELECTION, OUTPUT PARAMETERS AND

FORMAT SELECTION, COMM 1, SCANCODE SELECTION and

SYMBOLOGY SELECTION. These pages list the decoder parameters

controlled from that menu page and indicate the scanning sequence

required to make specific configuration selections. The symbols used to

control the configuration process are printed on the Bar Code Chart.

4.2.1 Programming Menu Pages

All SCANTEAM 2380 programming menus follow a similar layout and

contain the same programming elements. A typical programming menu

page is shown in Figure 4.1.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 67 68

No comments

Welch Allyn SCANTEAM 2380 WAND Specifications Page 25