Welch Allyn SCANTEAM 2380 WAND Specifications download pdf (Page 30)

4–6

Programming the Scanner

Note: The symbol “

” placed next to a programmable feature indicates that

this feature is not supported in all wand models/software revisions.

4.3 DIRECT CONNECT TERMINAL SELECTION Menu

Page

This menu page is used to make a direct connect terminal selection An

explanation of programmable selections follows.

Direct Connect Terminal Selection

The terminals that may be selected by scanning the appropriate direct

connect bar code are IBM AT and compatibles, IBM XT and compatibles,

and IBM PS/2 Model 30. The IBM AT, XT or PS/2 is configured by

scanning the one bar code on this page, instead of scanning the ENTER

code, the two digit terminal identifier code and the EXIT code on the

TERMINAL SELECTION menu page.

4.4 TERMINAL SELECTION Menu Page

This menu page lists the types of host devices which are supported by the

2380, and shows the scanning sequence that should be used to configure

the scanner interface to be compatible with a particular host PC.

4.5 OUTPUT PARAMETERS & FORMAT SELECTION Menu

Page

This menu page contains parameter selections used to control the data

message that will be sent from the scanner to the host. An explanation of

programmable selections follows.

Preamble

Preambles are assigned using the programming menu. When the Preamble

selection is enabled, any combination of up to five (5) identifiers are

transmitted as a header immediately preceding scanned bar code data.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 67 68

No comments

Welch Allyn SCANTEAM 2380 WAND Specifications Page 30